Filter
Top Products
25
3. GETTING STARTED
3.1. UNPACKING AND INITIAL SETUP
CAUTION
THE T200H AND THE T200M EACH WEIGHS ABOUT 18 KG (40 POUNDS) WITHOUT
OPTIONS INSTALLED. TO AVOID PERSONAL INJURY, WE RECOMMEND TO USE TWO
PERSONS TO LIFT AND CARRY THE ANALYZER.
Note It is recommended that you store shipping containers/materials for future
use if/when the instrument should be returned to the factory for repair
and/or calibration service. See Warranty section in this manual and
shipping procedures on our Website at http://www.teledyne-api.com
under Customer Support > Return Authorization.
WARNING
NEVER DISCONNECT ELECTRONIC CIRCUIT BOARDS, WIRING HARNESSES OR
ELECTRONIC SUBASSEMBLIES WHILE THE UNIT IS UNDER POWER.
1. Inspect the received packages for external shipping damage. If damaged, please
advise the shipper first, then Teledyne API.
2. Included with your analyzer is a printed record of the final performance
characterization performed on your instrument at the factory. This record, titled
Final Test and Validation Data Sheet (P/N 04413) is an important quality assurance
and calibration record for this instrument. It should be placed in the quality records
file for this instrument.
3. Carefully remove the top cover of the analyzer and check for internal shipping
damage, as follows:
a. Remove the set-screw located in the top, center of the front panel.
CAUTION – Avoid Warranty Invalidation
Printed circuit assemblies (PCAs) are sensitive to electro-static discharges too small to be
felt by the human nervous system. Damage resulting from failure to use ESD protection
when working with electronic assemblies will void the instrument warranty.
See A Primer on Electro-Static Discharge section in this manual for more information on preventing
ESD damage.
07270B DCN6512