Filter
Top Products
Operating Instructions Teledyne API - Model T200H/T200M Operation Manual
182
To assign or reset the status flag bit assignments, press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X. PMT DET WARNIN
G
: 0002
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. SYSTEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
<CH and CH>
move the [ ]
cursor left and
right along the
bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. See Table 6-29.
For example …
ENT
R
key accepts the
new settings
EXIT key ignores the new
settings
SETUP X. SYSTEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press the [?] keyrepeatedly to cycle through the available character set:
0
-9
Note: Values of A-F can also be set but are meaningless.
4.15.4.7. Instrument ID Code
Each instrument on a Hessen Protocol network must have a unique ID code. The
T200H/M has a default ID of either 0 or 200. To change this code see Section 4.11.1
07270B DCN6512