Filter
Top Products
119
Sampling
P0
P1 P2 P3 P4 P5 P8
3–2: Preference
3–2a: Create Zone Preference
Here you can specify the default settings for indices that are
created by executing “Create” (3–1c, 0–1b). New indexes
will be created according the settings you specify here. You
are free to modify the settings of an index later. Also, when
you execute “Insert” (3–1c), the “Position” setting specified
here will be used. (☞Create Zone Preference: 0–3a)
4–1: Controller Setup
Specifies the functions that the [SW1] key, [SW2] key, and
the B-mode functions of the REALTIME CONTROL knobs
[1]–[4] will have in Sampling mode.
In Sampling mode, it is not possible to use AMS to con-
trol program parameters.
4–1a: Pannel Switch Assign
Assigns the functions of the [SW1] and [SW2] keys (“SW1,
SW2 Assign List” ☞p.249).
SW1 (SW1 Assign) [Off...After Touch Lock]
SW1 Mode [Toggle, Momentary]
SW2 (SW2 Assign) [Off...After Touch Lock]
SW2 Mode [Toggle, Momentary]
☞Program P1: 1–4a
4–1b: Realtime Control Knobs B-Assign
Assigns the B-mode functions (mainly various types of con-
trol change) for the REALTIME CONTROL knobs [1]–[4]
(“Realtime Control Knobs B–Assign List” ☞p.250). The
functions you specify here will operate when the REAL-
TIME CONTROL knobs [1]–[4] are operated in B-mode.
Knob 1–B [Off...MIDI CC#95]
Knob 2–B [Off...MIDI CC#95]
Knob 3–B [Off...MIDI CC#95]
Knob 4–B [Off...MIDI CC#95]
☞Program P1: 1–4b
These controllers can be used to make realtime changes in
effect dynamic modulation functions etc. while you sample.
Example settings
Sample an external audio signal while using knob [1] (B-
mode) to adjust the “Wet/Dry” balance of 044: Stereo/Cross
Delay (assigned to IFX1) and knob [2] (B-mode) to adjust the
post-IFX “Pan” in realtime.
1 Set “BUS (IFX) Select” (0–2a) to IFX1.
2 Select 044: Stereo/Cross Delay for “IFX1.”
3 Set the IFX1 page “Wet/Dry” setting to Dry, “Src” to
KnobM1[+], and “Amt” to +50.
4 In Realtime Control Knobs B-Assign, set “Knob 1–B” to
Knob Mod.1 (CC#17), and set “Knob 2–B” to Post IFX
Pan (CC#08).
0–1G
0–1H
0–1I
0–1J
3–1A
0–1L
0–1M
0–1K
3–1
3–2a
Sampling P4: Controller Setup
0–1
4–1a
4–1b