Filter
Top Products
122
Here you can make insert effect settings for use in Sampling
mode.
If you want to apply insert effect IFX1–5 to the external
audio signal specified by “Input” and sample the result, set
the P0: Recording, Input/Setup page Input1 and Input2
“BUS (IFX/Indiv.) Select” parameters to IFX1–5, and adjust
the effect settings.
If you want to apply effects to a previously-sampled sample
or a sample you loaded, and resample the result, set the P8:
Insert Effect page “BUS (IFX) Select” parameter to IFX1–5,
and adjust the effect settings. (☞”Resample” 0–2b)
☞For details on insert effects, refer to p.178 “8. Effect
Guide.”
In Sampling mode, master effects 1 and 2 and the mas-
ter EQ cannot be used.
Insertion effect settings in Sampling mode are not
backed up when the power is turned off. If you wish to
keep the insertion effect settings, you can use “Copy
Insert Effect.”
For example, you can copy the insertion effect settings
of Sampling mode to a program or combination in
order save them. When you write the program or com-
bination, the settings will be saved in internal memory.
In Sampling mode, you can use “Copy Insert Effect” (8–
1A) to copy these effect settings from the program or
combination back into Sampling mode and use them.
8–1: Routing
8–1a: Routing Map
Routing Map
This displays the status of the insert effect settings.
Insert effect routing, the name of the specified effect, on/off,
and chain are displayed. Insert effect type, on/off, and chain
settings are made in the P8: Edit-Insert Effect, Insert FX
page.
8–1b: BUS Select
BUS(IFX) Select [L/R, IFX1...5, 1...4, 1/2, 3/4, Off]
Selects the bus.
If you want to apply an effect to a sample (multisample) that
you sampled or loaded, select IFX1–5. (☞“Resample” 0–2b)
After you resample, L/R will automatically be selected
as the “BUS (IFX) Select” setting. Be aware of this
when you want to resample again.
▼ 8–1: Page Menu Command
8–1A: Copy Insert Effect
☞“Program P8: 8–1A: Copy Insert Effect.”
8–1B: Swap Insert Effect
☞“Program P8: 8–1B: Swap Insert Effect.”
8–2: Insert FX
Here you can select insert effects, switch them on/off, make
chain settings, and specify the pan of the sound after pass-
ing through the insert effect.
These parameters are the same as in Program mode. Refer to
Program mode “8–2: Insert FX”
8–3: IFX 1
8–4: IFX 2
8–5: IFX 3
8–6: IFX 4
8–7: IFX 5
Set the effect parameters for the IFX 1, 2, 3, 4 and 5 effects
that you selected in the Insert FX page (☞p.187–).
Effect Dmod (dynamic modulation) is controlled by the
global MIDI channel specified in Global Mode P1.
Sampling P8: Insert Effect
8–1
8–1b
8–1a
8–1A
8–1B
8–1
8–2b
8–2a