Filter
Top Products
30
Category/IFX Select menu:
When you press the popup button, a “Category/IFX Select”
list will appear. Press a tab to select a category of effects, and
select an effect from that category. Press the OK button to
execute, or press the Cancel button to cancel.
IFX1, 2, 3, 4, 5 On/Off [Off, ON]
Switches the insert effect on/off.
When this is OFF, the input will be output unchanged. (For
000: No Effect, on/off will produce the same result.)
Each time you press this, the setting will alternate between
on/off.
Control change #CC92 can be used to turn off all of the
insert effects at once. A value of 0 will be off, and a
value of 1–127 will be the original setting. This message
is received on the global MIDI channel specified by
“MIDI Channel” (Global P1: 1–1a).
Chain [Off, On]
Switch “chain” on/off for each insert effect.
For example if the “Chain” check box between IFX1 and
IFX2 is checked, IFX1 and IFX2 will be connected in series. If
“BUS Select” (8–1c) is set to IFX1, IFX1 and IFX2 will be
inserted in series.
A maximum of five insert effects (IFX1–IFX5) can be
inserted in series. When effects are chained, the “PAN
(CC#8),” “BUS Select,” “Send 1” and “Send 2” settings that
follow the last IFX in the chain will be used.
Pan(CC#8) (Post IFX PanCC#8) [L000...C064...R127]
Sets the pan after the sound has passed through the insert
effect. This setting is valid only when the following “BUS
Select” is set to L/R (☞p.181).
CC#8 will control the pan of the sound after it has
passed through the insert effect.
BUS Sel. (BUS Select) [L/R, 1, 2, 3, 4, 1/2, 3/4, Off]
Specifies the bus to which the sound will be sent after pass-
ing through the insert effect. Normally you will set this to L/
R. If you wish to output to AUDIO OUTPUT (INDIVID-
UAL), set this to 1, 2, 3, 4, 1/2, or 3/4. The Off setting is used
when you wish to use “Send 1” and “Send 2” and in addi-
tion connect to the master effects in series.
Send1 [000...127]
Send2 [000...127]
Sets the send levels to the master effects 1 and 2 for the
sound that has passed through the insert effect. These set-
tings are valid when “BUS Select” (8–2a) has been set to L/R
or Off.
Control change CC#93 will control the Send 1 level, and
control change CC#91 will control the Send 2 level.
These messages are received on the global MIDI chan-
nel specified by “MIDI Channel” (Global P1: 1–1a).
8–3: IFX 1
8–4: IFX 2
8–5: IFX 3
8–6: IFX 4
8–7: IFX 5
Here you can set the effect parameters for the IFX 1/2/3/4/
5 that were selected in the Insert FX page (☞p.187–).
Effect dynamic modulation (Dmod) is controlled on the
global MIDI channel “MIDI Channel” (Global P1: 1–1a).
(“D.mod” ☞p.247)
Chain
0–1