Filter
Top Products
272
A
Already connected
Are you sure ?
B
Battery voltage for Calender IC is low
Buffer overrun error occurred
Buffer underrun error occurred
C
Can’t calibrate
Can’t copy/swap double size effect
Can’t open pattern Continue ?
Completed
Connection protected
D
Destination and source are identical
Destination from-measure within the limits of source
Destination is empty
Destination measure is empty
Destination multisample already exists
Destination multisample and source multisample are
identical
Various messages
Meaning: When you pressed the Connect button to execute
a connection in the Global mode mLAN Output/
Input page, a connection had already been set for
the specified input plug.
Action: Check the connection data of the receiving mLAN
device. If the plug and connection have already
been specified on the receiving device, it is possi-
ble that the current display is out of date, so re-
select the mLAN Output/Input page to re-display
it. If a connection from another output plug was
assigned to the input plug, break this connection
and then re-execute it.
Meaning: This message asks you to confirm execution. To
execute press the OK button. To cancel, press the
Cancel button.
Meaning: The calendar backup battery has run down.
Action: Replace the battery as described in “Replacing the
calendar backup battery” (☞p.286, 298).
Meaning: While sampling to the hard disk, the disk could
not be written fast enough to keep up with sam-
pling.
Action: Execute the Disk mode Utility page menu com-
mand “Check Medium.” If this does not solve the
problem, copy several files from the hard disk to
other media, then erase those files and execute the
operation again.
Meaning: While playing back a WAV file from the hard disk,
the disk could not be read fast enough for play-
back processing.
Action: Copy the desired file to another folder etc., and
then execute once again.
Meaning: Calibration could not be performed correctly.
Action: Try again.
Meaning: When copying or swapping an insertion effect,
you attempted to place a double-size effect in
IFX1 or IFX5.
Action: Modify your settings so that a double-size effect is
not moved to IFX1 or 5, and execute again.
Meaning: When you finished recording or editing, it was
not possible to allocate enough memory to open
the pattern that was Put into the track. (When it
must be opened automatically.) If you press the
OK button, the pattern data will be deleted, and
the recorded or edited content will be saved. If
you press the Cancel button, the recorded or
edited content will be discarded.
Meaning: Execution of the command ended normally.
Meaning: When you pressed the Cut button to break a con-
nection in the Global mode mLAN Output/Input
page, the specified connection was protected, and
cannot be broken.
Action: Defeat the protect setting on the mLAN device
from which protection was applied, and then
press the Cut button once again.
Meaning: When copying or bouncing, the same cue list,
song, track or pattern was selected for both the
source and destination.
Action: Select a different cue list, song, track, or pattern
for the source and destination.
Meaning: When executing the Move Measure command for
all tracks or within the same track, the specified
destination measure is within the source range.
Action: Set a destination measure that is outside of the
source range.
Meaning: When editing, the track or pattern that was speci-
fied as the destination contains no musical data.
Action: Select a track or pattern that contains musical
data.
Meaning: The measure that was specified as the destination
contains no data.
Action: Specify a destination measure that contains data.
Meaning: A multisample already exists at the destination
(save location) multisample.
Action: Either delete the multisample at the destination
(save location), or change the save destination
multisample number.
Meaning: The same multisample is selected for the source
and destination.
Action: Select different multisamples for the source and
destination.