Filter
Top Products
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
122
4.3.1.2. Naming a Sequence
The first step of creating a calibration sequence is to assign it a name. The name can be
up to 10 characters and can be comprised of any alpha character (A to Z), and numeral
(0 to 9) or the underscore character (“_“).
Note
All sequences should be assigned a unique name.
To assign a name to a sequence, press:
SETUP X.X NAME:[0]
<CH CH> INS DEL [0] ENTER EXIT
EXIT discards the
new NAME
ENTR accepts the
new NAME
Toggle this button to
cycle through the range of
numerals and available
characters:
(“A – Z”; “0 – 9” & “ _ ”)
Moves the
cursor one
character left or
right.
Deletes a
character at the
cursor location.
Inserts a new a
character at the
cursor location.
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
06873B DCN6388