Filter
Top Products
Teledyne API – Model T700 Dynamic Dilution Calibrator Introduction
25
Option
Option
Number
Description/Notes Reference
CAUTION – GENERAL SAFETY HAZARD
THE T700 CALIBRATOR WEIGHS CLOSE TO 18 KG (40 POUNDS) WITH ALL OPTIONS. TO AVOID
PERSONAL INJURY WE RECOMMEND THAT TWO PERSONS LIFT AND CARRY IT BUT FIRST
DISCONNECTING ALL CABLES AND TUBING FROM THE CALIBRATOR BEFORE MOVING IT.
Parts Kits Spare parts and expendables for 1-year operation
46A
Kit, Spares for One Unit
(Customer Svc)
46B
Photometer Kit, Spares for One Unit
(Customer Svc)
46C
Photometer W/ IZS Spares Kit For 1 Unit
(Customer Svc)
Communications For remote serial, network and Internet communication with the analyzer.
Type Description
60A RS-232
Shielded, straight-through DB-9F to DB-25M cable, about
1.8 m long. Used to interface with older computers or
code activated switches with DB-25 serial connectors.
Section 3.3.1.7
60B RS-232
Shielded, straight-through DB-9F to DB-9F cable of about
1.8 m length.
Section 3.3.1.7
60C Ethernet
Patch cable, 2 meters long, used for Internet and LAN
communications.
Section 3.3.1.7,
4.7.2, and 5.4
Cables
60D USB
Cable for direct connection between instrument (rear
panel USB port) and personal computer.
Section 3.3.1.7
USB Port 64A For rear panel connection to personal computer.
Sections 4.7 and
5.4.3
RS-232 Multidrop 62
Multidrop/LVDS card seated on the analyzer’s CPU card.
Each instrument in the multidrop network requres this card and a
communications cable (Option 60B).
Sections 3.3.1.7
and 4.7.3
External Valve Driver Capability - For driving up to eight, 8-watt valves
48A 12V External Valve Driver Capability
48B 24V External Valve Driver Capability
Section 3.3.1.6
NIST Traceable, Primary Standard Certification for use as a Primary Ozone Standard if purchased with the O
3
generator and photometer options, 1A and 2A, respectively.
95A Factory Calibration
95B Calibration as a Primary Standard
95C Calibration to NIST-SRP
Section 3.3.2.2
For this application the T700 Dynamic Dilution Calibrator’s performance is calibrated to Standard Reference Photometer
(SRP). Calibrators ordered with this option are verified and validated in accordance with procedures prescribed by the U.S.
Environmental Protection Agency (EPA) under Title 40 of the Code of Federal Regulations, Part 50, Appendix D.
Special Features Built in features, software activated
N/A
Maintenance Mode Switch, located inside the instrument, places
the analyzer in maintenance mode where it can continue sampling,
yet ignore calibration, diagnostic, and reset instrument commands.
This feature is of particular use for instruments connected to
Multidrop or Hessen protocol networks.
Call Customer Service for activation.
N/A
N/A
Second Language Switch activates an alternate set of display
messages in a language other than the instrument’s default
language.
Call Customer Service for a specially programmed Disk on Module containing
the second language.
N/A
06873B DCN6388