Filter
Top Products
Calibration and Verification Teledyne API – Model T700 Dynamic Dilution Calibrator
214
7.4.2.2. Adding or Editing O
3
Generator Calibration Points
To add a calibration point to the table or edit an existing point, press:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
Make sure that the T700 is
in standby mode.
SETUP X.X
GAS SEQ CFG CLK PASS EXIT
SETUP X.X
COMM FLOW VARS EXIT
SETUP X.X
EXIT
Toggle these buttons to
enter the correct
DIAG
PREV ENTR EXIT
DIAG
PREV NEXT EXIT
Continue pressing until ...
DIAG
CAL EXIT
Toggle these buttons to the place in the
table where the point is to be added or
edited. New Points are inserted
BEFORE the displayed point.
DIAG O3GEN
DEL PRNT EXIT
discards
the new setting
accepts
the new setting
DIAG O3GEN
EXIT
Toggle these buttons to move
between calibration points
parameters
DIAG O3GEN
EXIT
Toggle these buttons to set
the drive voltage
DIAG O3GEN
<SET EDIT EXIT
DIAG O3GEN
EXIT
Toggle these buttons to set
the dwell time for the point.
DIAG O3GEN
<SET SET> EXIT
DIAG O3GEN
<SET EDIT EXIT
DIAG O3GEN
Toggle these buttons to set
the dwell time for the point.
DIAG O3GEN
<SET SET> EXIT
discards
the new setting
accepts
the new setting
discards
the new setting
accepts
the new setting
06873B DCN6388