Filter
Top Products
APPENDIX A-1: Software Menu Trees, Revision D.3 (05623D DCN5839) T700, M700E Calibrator Manuals
A-8
EDIT
PRNTDELINSNEXTPREV
Cycles through list of
already programmed
calibration sequences
NOYES
SET><SET
Create/edit the name of the channel
Number of times to execute the same sequence
repeatedly (1 - 100 or 0 to execute indefinitely).
Enables or Disables the calibrator's digital contact closure
inputs that can be used to initiate the sequences remotely
Enables or Disables the calibrator's
digital contact closure outputs.
Enables or Disables the calibrator's timer feature that allows
the calibrator to use its internal clock to start a sequence
PROGRESS MODES
NAME
REPEAT COUNT
CC INPUT
TIMER ENABLE
CC OUTPUT
STEPS
EXITREMELAPPCTSTEP
ENTR
As the sequence runs,
the calibrator's display
will show progress by
displaying the step
currently being executed
As the sequence runs,
the calibrator's display
will show progress as a
percent of its total
programmed duration
As the sequence runs,
the calibrator's display
will show progress as
elapsed time.
As the sequence runs, the
calibrator's display will show
progress as the time remaining
of its total programmed
duration
Inserts a new sequence Edits existing sequence
NEXTPREV
Cycles through
list of sequence
commands
DELINS
NOYES
Inserts a new step
EDIT
Edits programmed
parameters for selected
step (See Chapter 6 for
further instructions).
GENERATE
GPT
GPTPS
PURGE
STANDBY
DURATION
EXECSEQ
SETCCOUTPUT
MANUAL
See Chapter 6 for further
instructions on programming each
of these commands
EXIT
MAIN MENU SETUP SEQ
EDIT PRNT EXIT
Figure A-5: PRIMARY SETUP Menu - SEQUENCE CONFIGURATION Submenu
06873B DCN6388