Filter
Top Products
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
152
To configure the calibrator’s TEST CHANNEL, set the electronic signal type of each
channel and calibrate the outputs. This consists of:
Choosing a Test Channel function to be output on the channel (Table 4-14).
Selecting a signal level that matches the input requirements of the recording device
attached to the channel (Section 4.10.1.3).
Determining if the over-range feature is needed and turn it on or off accordingly
(Section 4.10.1.4).
Adding a bipolar recorder offset to the signal if required (Section 4.10.1.5).
Calibrating the output channel. This can be done automatically or manually for each
channel (Section 4.10.1.6).
06873B DCN6388