Filter
Top Products
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
168
4.11.5. PROGRAMMING NEW LEVELS
To begin programming a new LEVEL find the LVL submenu by pressing:
CHOOSE ACTION Submenu
SETUP X.X ACTION TO PERFORM:GENERATE
PREV NEXT ENTR EXIT
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
LVL GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X END OF LEVELS
INS PRNT EXIT
SETUP X.X [LEVEL ID] ) [Gas/Conc.], [Status Block Set]
PREV NEXT INS DEL EDIT PRNT EXIT
Deletes the LEVEL shown
in the message field
Edits the LEVEL shown in
the message field
Scrolls back and forth between
existing LEVELS
This display only appears if there are no LEVELs currently
programmed into the M700E.
OTHERWISE ...
Use these buttons to scroll though the available
instructions: GENERATE, GPT, GPTPS & MANUAL
06873B DCN6388