Filter
Top Products
Teledyne API – Model T700 Dynamic Dilution Calibrator Overview of Operating Modes and Basic Operation
125
To specify a starting date and time for the sequence, press:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X TIMER ENABLE:ENABLED
<SET SET> EDIT EXIT
SETUP X.X TIMER START: 01-JAN-06 00:00
<SET SET> EDIT EXIT
SETUP X.X TIMER START: 01-JAN-06 00:00
0 1 JAN 0 6 ENTR EXIT
EXIT discards the
new setting
ENTR accepts the
new setting
Toggle these
buttons to enter
starting day, month
and year.
DAY MONTH YEAR
SYSTEM TIME: 12:00
1 2 :0 0 ENTR EXIT
HOUR MINUTE
Toggle these
buttons to enter the
start time
EXIT discards the
new setting
ENTR accepts the
new setting
Note When the start time is set for a date/time that has passed, the sequence
will properly calculate the next run time based on that past date/time.
06873B DCN6388