Filter
Top Products
T700, M700E Calibrator Manuals APPENDIX A-3: Warnings and Test Functions, Revision D.3 (05623D DCN5839)
A-21
APPENDIX A-3: Warnings and Test Functions, Revision D.3
Table A-2: Warning Messages, Revision D.3
Name
1
Message Text Description
Warnings
WSYSRES SYSTEM RESET
Instrument was power-cycled or the CPU
was reset.
WDATAINIT DATA INITIALIZED Data storage was erased.
WCONFIGINIT CONFIG INITIALIZED
Configuration storage was reset to factory
configuration or erased.
WPHOTOLTEMP PHOTO LAMP TEMP WARNING
Photometer lamp temperature outside of
warning limits specified by PHOTO_LAMP
variable.
WO3GENTEMP O3 GEN LAMP TEMP WARNING
O
3
generator lamp temperature outside of
warning limits specified by
O3_GEN_LAMP variable.
WPERMTEMP1 PERM TUBE #1 TEMP WARNING
Permeation tube #1 temperature outside
of warning limits specified by
PERM_SET1 variable.
WPERMTEMP2
3
PERM TUBE #2 TEMP WARNING
Permeation tube #2 temperature outside
of warning limits specified by
PERM_SET2 variable.
WPHOTOREF PHOTO REFERENCE WARNING
Photometer reference reading less than
2500 mV or greater than 4999 mV.
WLAMPSTABIL PHOTO LAMP STABILITY WARNING
Photometer lamp reference step changes
occur more than 25% of the time.
WO3GENREF O3 GEN REFERENCE WARNING
O
3
reference detector drops below 5 mV
during reference feedback O
3
generator
control.
WREGPRESS REGULATOR PRESSURE WARNING
Regulator pressure outside of warning
limits specified by REG_PRESS_LIM
variable.
WMFCPRESS MFC PRESSURE WARNING
Any MFC pressure outside of warning
limits specified by PRESS_LIMIT variable.
WMFCFLOW MFC FLOW WARNING
Any MFC drive less than 10% of full scale
or greater than full scale.
WMFCCAL MFC CALIBRATION WARNING
Any MFC sensor offset greater than
allowable limit.
WO3PUMP O3 PUMP WARNING
O
3
pump failed to turn on within timeout
period specified by O3_PUMP_TIMEOUT
variable.
WOUTPUT INVALID OUTPUT WARNING
An invalid output has been selected for
the requested gas generation. For
example, output B was selected when
generating ozone.
WREARBOARD REAR BOARD NOT DET
Rear board was not detected during
power up.
WRELAYBOARD RELAY BOARD WARN
Firmware is unable to communicate with
the relay board.
WVALVEBOARD VALVE BOARD WARN
Firmware is unable to communicate with
the valve board.
WLAMPDRIVER LAMP DRIVER WARN
Firmware is unable to communicate with
either the O
3
generator or photometer
lamp I
2
C driver chip.
06873B DCN6388