Filter
Top Products
Teledyne API – Model T700 Dynamic Dilution Calibrator Overview of Operating Modes and Basic Operation
127
4.3.1.5. Setting Up Control Inputs for a Sequence
The T700 calibrator’s control inputs allow the entire sequence to be triggered from an
external source. This feature allows the calibrator to operate in a slave mode so that
external control sources, such as a data logger can initiate the calibration sequences.
Each of the T700 calibrator’s control outputs is located on the back of the instrument
(see Figure 3-4).
12 separate ON/OFF switches assigned to separate calibration sequences or;
A 12-bit wide bus allowing the user to define activation codes for up to 4095
separate calibration sequences.
To assign a CC INPUT pattern/code to a particular sequence, press:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure toT700 is in
standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
SETUP X.X CC INPUT:DISABLED
<SET SET> EDIT EXIT
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X CC INPUT:[0]00000000000
<CH CH> [0] ENTER EXIT
EXIT discards the
new setting
ENTR accepts the
new setting
SETUP X.X CC INPUT ENABLE:OFF
OFF ENTER EXIT
Toggle this
button turn the
CC input ON/
OFF
EXIT discards the
new setting
ENTR accepts the
new setting
Moves the
cursor one
character left or
right.
Toggle this button to turn the selected bit ON/OFF (0 or 1).
Each bit shown on the display represents one of the control
input pins located on the back of the T700 (see Figure 3-2),
The left most bit is Bit 1, the next bit to the right, bit 2,
progressing rightward to bit 12 (see Figure 3-9 for connector
pin assignments)
06873B DCN6388