Filter
Top Products
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
150
To access and navigate the VARS menu, use the following button sequence:
DO NOT CHANGE
these settings unless
specifically instructed to by
Teledyne Instruments’
Customer Service
personnel
STANDBY A-CAL=0.0000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM FLOW VARS DIAG EXIT
SETUP X.X ENTER PASSWORD
818 ENTREXIT
Toggle these buttons to
enter the correct
PASSWORD
SETUP X.X 0) O3_PHOTO_LAMP=58.0 DegC
NEXT JUMP EDIT PRNT EXIT
SETUP X.X 1) O3_PHOT_LAMP=58.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 2) O3_CONC_RANGE=500.0 PPB
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X O3_CONC_RANGE=500.0 PPB
0 0050.0ENTREXIT
Toggle these buttons to set
the upper span point of the
O3_PHOTO_CONC Test
Channel signal
In all cases:
EXIT discards the new
setting
ENTR accepts the
new setting
SETUP X.X 3) O3_PHOTO_BENCH_ONLY=OFF
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X O3_PHOTO_BENCH_ONLY=OFF
OFF 0 ENTR EXIT
Toggle this button turn this
mode ON / OFF
DO NOT CHANGE
these settings unless
specifically instructed to by
Teledyne Instruments’
Customer Service
personnel
SETUP X.X 4) STD_TEMP=25.0 DegC
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 5) STD PRESS=29.92 In-Hg
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 6) CLOCK_ADJUST=0 Sec/Day
PREV JUMP EDIT ENTR EXIT
SETUP X.X CLOCK_ADJUST=0 Sec/Day
+0 0 ENTR EXIT
Enter sign and number of
seconds per day the clock
gains (-) or loses(+)
06873B DCN6388