Filter
Top Products
Getting Started Teledyne API – Model T700 Dynamic Dilution Calibrator
32
1. Inspect the received packages for external shipping damage. If damaged, please
advise the shipper first, then Teledyne API.
2. Included with your calibrator is a printed record of the final performance
characterization performed on your instrument at the factory. This record, titled
Final Test and Validation Data Sheet (P/N 05731) is an important quality assurance
and calibration record for this instrument. It should be placed in the quality records
file for this instrument.
3. Carefully remove the top cover of the calibrator and check for internal shipping
damage.
Remove the locking screw located in the top, center of the Front panel.
Remove the two screws fastening the top cover to the unit (one per side towards
the rear).
Slide the cover backwards until it clears the calibrator’s front bezel.
Lift the cover straight up.
4. Inspect the interior of the instrument to ensure all circuit boards and other
components are in good shape and properly seated.
5. Check the connectors of the various internal wiring harnesses and pneumatic hoses
to ensure they are firmly and properly seated.
6. Verify that all of the optional hardware ordered with the unit has been installed.
These are checked on the paperwork accompanying the calibrator.
3.1.1. VENTILATION CLEARANCE
Whether the calibrator is set up on a bench or installed into an instrument rack, be sure
to leave sufficient ventilation clearance.
AREA MINIMUM REQUIRED CLEARANCE
Behind the instrument 10 cm / 4 inches
Sides of the instrument 2.5 cm / 1 inch
Above and below the instrument. 2.5 cm / 1 inch
Various rack mount kits are available for this calibrator. See Table 1-1 of this manual
for more information.
3.2. CALIBRATOR LAYOUT
Figure 3-1 shows the calibrator’s front panel layout, followed by a close-up of the
display/touchscreen in and description in Table 3 1. The two USB ports on the front
panel are provided for the connection of peripheral devices:
plug-in mouse (not included) to be used as an alternative to the touchscreen
interface
thumb drive (not included) to download updates to instruction software (contact T-
API Customer Service for information).
WARNING!
NEVER DISCONNECT ELECTRONIC CIRCUIT BOARDS, WIRING HARNESSES
OR ELECTRONIC SUBASSEMBLIES WHILE THE UNIT IS UNDER POWER.
06873B DCN6388