Filter
Top Products
31
3. GETTING STARTED
This section addresses the procedures for unpacking the instrument and inspecting for
damage, presents clearance specifications for proper ventilation, introduces the
instrument layout, then presents the procedures for getting started: making electrical and
pneumatic connections, and conducting an initial calibration check.
3.1. UNPACKING AND INITIAL SETUP
CAUTION – RISK of Personal Injury
THE T700 WEIGHS ABOUT 18 KG (40 POUNDS) WITHOUT OPTIONS INSTALLED.
TO AVOID PERSONAL INJURY, WE RECOMMEND USING TWO PERSONS TO
LIFT AND CARRY THE CALIBRATOR.
ATTENTION
COULD DAMAGE INSTRUMENT AND VOID WARRANTY
Printed Circuit Assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Failure to
use ESD protection when working with electronic assemblies will void
the instrument warranty. See A Primer on Electro-Static Discharge in
this manual for more information on preventing ESD damage.
Note Teledyne API recommends that you store shipping containers/materials
for future use if/when the instrument should be returned to the factory for
repair and/or calibration service. See Warranty section in this manual and
shipping procedures on our Website at http://www.teledyne-api.com
under Customer Support > Return Authorization.
CAUTION – Avoid Damage to the Instrument
BEFORE oprating instrument, remove dust plugs from pneumatic ports.
06873B DCN6388