Filter
Top Products
Teledyne API – Model T700 Dynamic Dilution Calibrator Overview of Operating Modes and Basic Operation
131
4.3.2. ADDING SEQUENCE STEPS
To insert an instruction step into a sequence, navigate to the INSERT STEP submenu
by pressing:
INSERT STEP Submenu
STEPS Submenu
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X STEPS: 1
<SET SET> EDIT EXIT
SETUP X.X 1) STANDBY
PREV NEXT INS DEL EXIT
Use these
buttons to scroll
though existing
instructions
Deletes the
instruction
shown in the
message field
To add an isntruction, press next until ...
SETUP X.X END OF STEPS
PREV INS EXIT
SETUP X.X INSERT STEP: GENERATE
PREV NEXT ENTR EXIT
06873B DCN6388