Teledyne T700 Microphone User Manual


 
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
126
To set the delta timer, press:
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ SETUP
Make sure that the T700 is
in standby mode.
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X TIMER DELTA: 001:00:00
<SET SET> EDIT EXIT
SETUP X.X TIMER DELTA: 0 Days
00 0 ENTREXIT
Toggle these buttons to
enter number of days to
wait between before
running sequence again.
EXIT discards the
new setting
ENTR accepts the
new setting
SYSTEM TIMER DELTA 00:00
1 2 :0 0 ENTR EXIT
HOUR MINUTE
Toggle these
buttons to enter the
amount of time to
wait before running
the sequence again.
EXIT discards the
new setting
ENTR accepts the
new setting
06873B DCN6388