Filter
Top Products
Overview of Operating Modes and Basic Operation Teledyne API – Model T700 Dynamic Dilution Calibrator
174
4.11.6. CONFIGURING LEVEL STATUS BLOCKS
There are two STATUS BLOCKS associated with LEADS LEVELS.
BLOCK 1: This block corresponds to the physical CONTROL OUTPUT connections
located on the back panel of the T700 (see Figure 3-4 and Section 3.3.1.5).
BLOCK 2: The se
cond status block does not correspond to any physical output but
is used to communicate status over the serial data port.
To configure the either of the STATUS BLOCKS, press:
06873B DCN6388