Filter
Top Products
Sampling (Open Sampling System)
132
When the power is first turned on, the assigned
sample will be set to “Orig.Key C2.
2. Make the following settings.
– INPUT1 –
Bus Select (IFX/Indiv.): Off
Turn off the input from the INPUT 1–4 and S/P DIF
L/R jacks.
– Sampling Setup –
Source Bus: L/R
The sound sent to the L/R will be sampled.
Trigger: Sampling START SW
After you’ve pressed the SAMPLING REC switch
to enter sampling-ready mode, resampling will
begin when you press the SAMPLING
START/STOP switch.
Resample: Auto
The sample assigned to the index will be resampled
automatically.
Key: C2
Use Key to specify the sample that will be
resampled.
Recording Level: 0.0
This is the default setting for resampling.
Save to: RAM
The data will be written to RAM memory.
Sampling Mode: Stereo
The sound of the internal L/R channels will be
sampled in stereo.
Auto +12dB On: On
The +12 dB setting will automatically be turned on
for the samples you record.
Be aware that if you change the Bus setting from Off
to L/R or IFX1–12, the volume level sent to the
AUDIO OUT L/MONO and R jacks and the
headphones may rise excessively.
3. In P2: Loop Edit, check the +12 dB setting.
4. In the P8: Insert Effect– Routing page, set Bus
Select to IFX1.
5. In the P8: Insert Effect, Insert FX page, set IFX1 to
101: Reverb Hall, and turn IFX On/Off ON.