Filter
Top Products
Creating songs (Sequencer mode)
82
To change the registered location, use the “Set
Location” page menu command. Alternatively, you
can register a location during playback by holding
down the ENTER switch and pressing the LOCATE
switch.
When you select a song, the “LOCATE” setting is
automatically initialized to 001:01.000.
For more information, see “Set Location (for Locate
Key)” on page 525 of the Parameter Guide.
Loop playback
When recording or playing back a song, you can
individually loop the MIDI tracks that are playing.
In the P0: Play/REC– MIDI Track Loop page, check
“Track Play Loop” for the MIDI tracks you want to
loop, and use “Loop Start Measure” and “Loop End
Measure” to specify the starting and ending measure
of the region that will play back as a loop.
If you check “Play Intro,” the measures preceding the
loop will be played back as an introduction before the
loop begins.
If you play back from the first measure with the
settings shown in the screenshot below, the specified
region of measures will repeat as follows.
If “Play Intro” is unchecked, the specified region of
measures will repeat as follows.
Measures 123456789
1
0
1
1
1
2
1
3
Track 1 1 2 3 4 5 6 7 8 5 6 7 8 5
Track 2 ----9
1
0
9
1
0
9
1
0
9
1
0
9
Measures 123456789
1
0
1
1
1
2
1
3
Track 1 5 6 7 8 5 6 7 8 5 6 7 8 5
Track 2 9
1
0
9
1
0
9
1
0
9
1
0
9
1
0
9
1
0
9
Loop Start
Measure
Track Play
Loop
Play Intro
Loop End
Measure