Filter
Top Products
Playing Songs The control surface in Sequencer mode
81
MIX SELECT: Press these buttons to select the current
track. This current track applies to the channel strip
(when MIXER KNOBS is set to CHANNEL STRIP),
and to Tone Adjust.
You can also use these buttons to change the
Keyboard/Rec track, so that you can switch between
tracks directly from the Control Surface. To do this:
1. Go to the Control Surface tab of the P0: Play page.
2. Set CONTROL ASSIGN to TIMBRE/TRACK,
using either the front-panel button or the on-
screen tab.
3. Check the box on the right-hand side of the screen,
labeled Link KBD/REC Trk to Ctrl Surface.
Now, you’ll be able to change the Keyboard/Rec track
directly from the Control Surface.
If you press the SOLO switch, the MIX SELECT
buttons will control the Solo On/Off status. The Solo
behavior will depend on the Exclusive Solo setting.
Note: If any MIDI track, Audio track, or audio input is
soloed, the SOLO switch LED will blink.
Tip: To turn Solo off for all tracks, hold down the
RESET CONTROLS button and press the SOLO
button.
Tip: To turn Mute off for all tracks, hold down the
RESET CONTROLS button and press the
TIMBRE/TRACK button.
AUDIO
When AUDIO is selected, the control surface will edit
the pan, EQ, effect send, Play/Rec/Mute status, Solo
On/Off status, and volume of the audio inputs or
audio tracks.
The LEDs at the right of the AUDIO switch indicate
whether audio inputs (INPUTS), audio tracks 1–8, or
audio tracks 9–16 are currently selected. The sliders,
knobs, and switches will control the respective set of
inputs or tracks.
KNOBS: If you press the MIXER KNOBS switch to
make the INDIVIDUAL PAN LED light, the knobs will
control the Pan setting of the six inputs, tracks 1–8, or
tracks 9–16. If the CHANNEL STRIP LED is lit, the
knobs will control the pan and effect sends for a single
input if INPUTS is selected. If HDR 1–8 or HDR 9–16
are selected, the knobs will control the pan, EQ, and
effect sends for a single track. Use the MIX SELECT
switches to select the input/track you want to control,
and use the knobs to control them.
MIX PLAY/MUTE, MIX SELECT: These switches work
in the same way as they do for TIMBRE/TRACK, as
described above.
EXTERNAL
When EXTERNAL is selected, the control surface is
used to transmit MIDI messages to an external MIDI
device. For more information, see “0–9e: External” on
page 444 of the Parameter Guide.
R.TIME KNOBS/KARMA
When R.TIME KNOBS/KARMA is selected, the sliders
and switches of the control surface are used to control
the KARMA function. For more information, see “0–9f:
RT (Real Time Knobs)/KARMA” on page 445 of the
Parameter Guide.
TONE ADJUST
When TONE ADJUST is selected, the control surface is
used to temporarily adjust the program used by each
MIDI track. For example while you’re creating a song,
you can use this capability to adjust the sound
appropriately for your song without going back to
Program mode; you might soften the tone of the bass
or speed-up the attack of a strings program, and make
these changes happen in realtime while the song plays.
Use Track in the right side of the LCD to select the
MIDI track you want to adjust.
For more information, see “0–9g: Tone Adjust” on
page 447 of the Parameter Guide.
LOCATE settings
You can press the LOCATE switch to move to the
registered location. Initially, this will move to
001:01.000.