Filter
Top Products
Settings for the entire OASYS (Global mode)
148
Linking KARMA to programs and
combinations
You can specify whether the KARMA settings written
to a program or combination will also be selected when
you select that program or combination, or whether
the KARMA settings will not change when you switch
the program or combination.
When the OASYS is shipped from the factory, the
former setting is selected. You can use the latter setting
if you want to use the same KARMA settings to
generate phrases and patterns while you select and try
out different programs and combinations.
If the Load KARMA Settings When Changing
Program or Combination boxes are selected, selecting
a program or combination respectively will also select
the KARMA settings that are written in that program
or combination.
Globally disabling KARMA
If All KARMA Off is enabled, all KARMA
functionality will be turned off. KARMA will not
operate even if the KARMA ON/OFF switch is on.
Recalling the last-selected mode and page
at power-on
The state of OASYS when the power is turned on will
depend on the setting of “Power On Mode”.
If Power On Mode is set to Reset (factory setting),
OASYS will automatically select the Combination
mode P0: Play.
If Power On Mode is set to Memorize, OASYS will
power on using the same mode and page that were
selected when the power was turned off.
Sounding a beep when you press the LCD
screen
If Beep Enable is selected, a beep will sound when you
press an object in the LCD screen. Uncheck this item if
you don’t want a beep to sound.
Protecting the memory
If one or more of the Memory Protect check boxes are
checked, operations such as writing, loading, or song
recording will be prohibited for the corresponding
type of memory.
Global audio settings
Making audio input settings for all modes,
except Sampling mode
The settings on the Audio tab select the input source
for the analog/digital audio signal, the input level,
bus, and master effect sends for use in all of the modes
(Program, Combi, etc.) except for Sampling mode. If
you want to use these settings, check the Use Global
Setting option in the desired Program, Combi, or Song.
Tuning and transpose
settings
Velocity/aftertouch curve
settings
Effect bypass settings
KARMA settings
Memory protect
settings
Select the mode that is
selected at power-on
Beep setting