Filter
Top Products
Saving data Writing to internal memory
167
Press the Shift button once again to switch to lowercase
characters, and press the characters r, o, g, r, a, m, 0, 1.
3. Press the OK button to close the dialog box.
If you don’t need to make any corrections, press the
OK button to close Write Program.
Memory protect
To prevent programs, combinations, songs, drum kits,
wave sequences, and KARMA GE from being
overwritten accidentally, the OASYS provides a
Memory Protect setting that prohibits writing to
memory.
Before you save edited data or load data from media,
use the following procedure to turn the memory
protect off (uncheck the appropriate check box).
You must also turn memory protect off before loading
the above data from media or via a MIDI data dump,
or before recording in Sequencer mode.
1. Press the GLOBAL switch to enter Global mode.
2. Access the Global P0: Basic Setup– Basic page, and
select the Basic page.
Press the Basic tab at the bottom, and then press the
Basic tab above it.
3. Press the “Memory Protect” check box for the type
of data you wish to write to internal memory, so
that the box is unchecked.
Writing global settings
The settings you edit in Global mode P0–P3 can be
written into internal memory as Global settings. If you
wish to use these edited settings after you turn the
power off, be sure to write the data first.
The wave sequences and drum kits you edit in Global
mode P4 and P5 must be written as individual wave
sequences and drum kits.
There are two ways to write global settings.
Using a page menu command to write
1. To write global settings (the various settings in
Global P0–P3), press the page menu command
Write Global Setting in Global P0–P3.
The Write Global Setting dialog box will appear.
Note: The same dialog box will also appear if, in each of
the above pages, you hold down the ENTER switch
and press the 0 switch. (See “Shortcuts” on page 182)
2. To execute the Write operation, press the OK
button. To cancel, press the Cancel button.
When you press the OK button, the display will ask
“Are you sure?” Press the OK button once again to
write the data.
Using the (SEQUENCER) REC/WRITE
switch to write
1. In the Global P0–P3 pages, press the SEQUENCER
REC/WRITE switch.
A dialog box will appear.
2. To execute the Write operation, press the OK
button. To cancel, press the Cancel button.
● Memory in Global mode P0–P3
When the power is turned on, the Global mode P0–P3
data is called from internal memory into the Global
mode memory area. Then when you modify the
parameters in Global mode, the data in the memory
area will be modified. If you wish to save this modified
data in internal memory, you must Write it.
When you write this data, the data in the memory area
is written into the global settings.
If you turn off the power without writing, the modified
data in the memory area will be lost.
Memory Area
Write
Power On
Internal Memory
Edit
Global Setting
P0...P3
Editing will affect the data that has
been called into the memory area.
When you Write, the
various Global mode
P0–P3 settings will be
saved in internal memory.
When the power is
turned on, the settings
are called into the
memory area.