Filter
Top Products
98
1b. Peak Hold Time [0…8s, ∞]
Specifies the amount of time that peaks will continue
to be displayed in the level meter.
0…8s: 0–8 seconds
∞: Continue holding the peaks
This setting applies to the level meters in each page.
1c. Select View [TrackView, FaderView]
Changes the content of the meter display.
2. Level meters
These display the levels of the channels, sends, and mon-
itor signals etc.
3. Track view window
In each track, regions that contain audio data are dis-
played in black.
The vertical line indicates the current location.
The top portion shows the locate points (→p.38).
4. Time location display
This bar indicates the entire song from the zero point to
the end point. This gives a relative indication of the cur-
rent location.
5. Track status window
This area shows the name of each track and the status of
its virtual tracks. Virtual tracks displayed in black are
currently in use.
6. Scale buttons
Use these buttons to magnify or shrink the area dis-
played in the track view window.
7. Name window
This displays the names of each track and of the master
effects.
8. Pan/Fader view
Here you can view and edit the following parameters.
Faders, CH ON, pan, EFF 1/2 Return Level, EFF 1/2
Return Balance
2-1. Ch View
This displays the settings and status for a single channel.
Press one of the CH SELECT keys to select the channel that
will be displayed.
In this screen you can set the following parameters.
• Pairing (→p.102)
• Pan (→p.103, [*107])
• Channel on/off (→p.8)
• Input (→p.100)
• Attenuator (→p.109)
• Phase (→p.110)
• Recording location (→p.111, [*113])
• Solo on/off (→p.113)
• EQ on/off, flat (→p.109)
• Fader (→p.103, [*107])
• Level meter position (→p.97)
•Group (→p.103) ....... D32XD
• Send (→p.112)
• EQ (→p.109)
Send and EQ parameters can also be edited using the Send and
equalizer knobs and keys located at the right of the display.
2-2. Channel Routing View
This displays a simplified signal flow for the channel shown
in the “Ch View” tab page.
You cannot edit the settings here.
Press one of the CH SELECT keys to select the channel that
will be displayed.
TrackView:Shows the level meters, existence of audio
events, and a list of virtual tracks
FaderView:Shows the level meters, and fader/pan/
channel-on status of each track
IN: OUT: TO: END:
7
8
D32XD Fader View
D16XD Fader View
7
8
2. CH VIEW
D32XD
D16XD