Filter
Top Products
32
In this way, the send value controls the level of each track being sent to this mas-
ter effect.
For the tracks you don’t want to use master effect 1, set the send value to “0.”
(4)Make settings for master effect 2 in the same way, using the “MstrEFF2”
and “EFFSend2” tab pages.
Checking and adjusting the master effect
(1)Press the PLAY key to play back the song.
As the song plays, listen to the output of the master bus to hear the results of
your effect settings.
(2)In the EFFECT, “MstrEFF1” (or “MstrEFF2”) tab page, adjust the return
level and return balance of the signal from the master effect to the master
bus.
For this example, set “Return Level” to “100,” and “Return Balance” to “C.”
(3)If the output level meter clips, press the TRIM knob icon in the LCD screen
and adjust the value until no clipping occurs.
For details on editing the parameters of the selected effect, refer to “4. Editing
the effects” (→p.59) in the Operation section.
2. Applying effects and EQ to the entire song
Checking the volume
Use the channel faders to adjust the playback level.
Press the METER key to display the Post Fader level meters.
Press the popup button to open the “Meter Trk Type” dialog box. Set the Select
Level Meter Position to “Post Fader,” and set Select View to “Track View.” Now
the meters will show the level for each fader.
Applying an effect to the master bus (Final Effect)
(1)Press the EFFECT key and select the “FinalEff” tab page.
(2)Press the popup button to open the Select EFF Category window, and select
a final effect category.
For this example press “Reverb&Delay.”
(2)
(1)
(2)
(1)