Filter
Top Products
33
Quick Start
Step 1: PreparationsStep 2: Quick recordingStep 3: OverdubbingStep 4: Mixdown and
mastering
(3)The Select EFF Program dialog box will appear. Here you
can select the effect.
For this example press “L/C/R Delay” and then press the
OK button. If you want to go back and look in another cate-
gory, press Cancel button.
(4)Press the PLAY key to play back the song. Listen to the
output of the master bus or the headphones to hear the
results of the final effect.
(5)Make the desired adjustments, and then press the STOP
key.
For details on editing the parameters of the effect that you
selected, refer to “4. Editing the effects” (→p.59) in the
Operation section.
Applying EQ to the master bus (Master EQ)
(1)Press the MIXER key, press the EQ/PHASE/REC [*EQ/ATT/PHASE] button
in the page jump menu, then select the “MasterEQ” tab page.
(2)For this example, press the Link button to turn it on (highlighted).
When the Link button is on, adjusting either side (left or right channel) will
make the same settings for both channels (→p.48).
(3)Make sure that the L button is on (highlighted); the display will show the
left channel master EQ screen.
(4)Press the PLAY key to play back the song.
(5)While listening to the output of the master bus or the headphones, select
the various EQ knob icons in the LCD screen and use the value dial (or the
+/– keys) to adjust the EQ settings.
The EQ window displays the EQ curve.
You can switch the master EQ on/off by pressing the ON/OFF button in the
LCD screen.
If you want to make independent settings for the left and right master EQ, turn off the Link
button and use the R or L button to select right or left.
The EQ knobs and keys at the right of the LCD screen will not adjust the master EQ.
(6)When you‘re done adjusting the master EQ, press the STOP key.
(3)
(3)
(1)
(1)
(1)
(5)
EQ window
(2)
Step 4: Mixdown and
mastering