Filter
Top Products
60
(4) Select the effect program that you want to control.
Press the EFFECT key for the effect you chose in step (3),
and select an effect program in the appropriate tab page.
(5) Specify the parameter and range that you want to con-
trol.
•A control icon will be added at the end of the effect
chain of the selected program. Press (highlight) this
control icon to display the control-related parameters.
•Turn “Control” on.
• Use the effect knobs to specify the range.
If you want to save these settings, store the program as de-
scribed on “Save Now” (→p.137).
(6) Operate your expression pedal or external MIDI con-
troller to control the effect parameter you specified.
6. Using external effects
You can output an effect send signal from the AUX OUT
jacks and use an external effect processor to apply effects.
Then connect the output of your external effect processor to
the INPUT 1–8 jacks and return the effect signal to the master
bus.
Sending the playback signal to an external effect proces-
sor, and using INPUT 3 and INPUT 4 jacks to return it to
the master bus
(1) Connect your external effect processor.
Connect one of the D32XD/D16XD’s AUX OUT jacks to
the INPUT jack of your external effect processor, and
connect the OUTPUT jacks of the effect processor to the
D32XD/D16XD’s INPUT 3 jack and INPUT 4 jack.
(2) Send the playback signal to the external effect.
• Access the MIXER, SEND (EFF/AUX
[*/REC]), “Aux-
Send” tab page.
• Select the knob icon of the channel that you want to
send to the external effect, and use the buttons
to adjust it.
•Press the button located above the knob icon to select
either pre-fader (PRE) or post-fader (PST) as the loca-
tion from which the signal will be sent to AUX.
(3) Input the audio signal from the external effect proces-
sor.
• Access the MIXER, INPUT/OUTPUT/CH ASSIGN
,
“SubMix 1-8” tab page.
• Adjust the “Level” of each channel to set the return
level, and adjust the “Pan” to set the return pan
(→p.101).
(5)
(5)
(5)