Filter
Top Products
81
Operation
Song,
Locate
MixerEffects
RhythmRecorder
CDDataDriveUSBMIDIUpgrading
the system
Touch Panel
Calibration
Press the Add button, select song A, and press the OK
button.
The display will ask “Are You Sure?” Press the Yes but-
ton.
If the selected song is 24-bit, press the Dither button to turn
it on if you want dithering to be performed.
The data will be written to CD as a 44.1 kHz song. If you se-
lect a song whose sampling rate is other than 44.1 kHz, the
data must be converted, and a certain amount of time will be
required for the conversion to be performed before the song ap-
pears in the track list.
The display will indicate “Completed.” Press the OK
button to return to the Album CD Project screen.
The locations at which you assigned the “Use As CD Tr”
marks will divide the song into tracks in the track list.
(6) Edit the album CD project. [Figure E]
• Delete unwanted tracks.
• The pre-gap and post-gap will both be zero between
tracks to which you assigned the “Use As CD Tr”
mark, but you may edit this if you wish.
(7) Play back the album CD project to check it.
(“2-1. Album CD Project” (→p.80), step (5))
(8) Perform steps (6)–(8) of “Album CD Project.”
You can also use this same method to create track indexes in-
side one single long song, so that a certain section can be ac-
cessed instantly.
CD