Filter
Top Products
12
38 Value dial
Use this dial to edit the value of the selected parameter or to change the current
time location. When the Scrub page is displayed, rotating this dial will play back
the track at the corresponding speed (up to a maximum of double speed).
39 ENTER key
Use this key to finalize a parameter setting or to switch a parameter on/off.
Front panel
1 GUITAR IN jack
You can plug a guitar or bass into this jack. The GUITAR IN jack shares the same
audio path as the INPUT 1 jack; if both jacks are connected to an audio source,
the GUITAR IN jack will take priority.
This is an unbalanced 1/4" phone jack with 1 MΩ input impedance.
2 EXPRESSION PEDAL jack
You can use a pedal to control a specified parameter of an insert effect. You can
control the parameter in realtime while you play or record. (→p.59)
Connect an expression pedal (separately sold option, EXP-2, XVP-10 etc.) to this
jack.
3 FOOT SW jack
When your hands are busy playing an instrument, you can use a foot switch to
control basic operations of the D32XD/D16XD recorder.
A foot switch can be used to start/stop the playback, start/end manual punch-in
recording, register a mark, or to record tap tempo. (
→
p.27, 64, 66, 126)
Connect a foot switch (optional PS-1) to this jack.
4 PHONES 1, 2 jack
A set of headphones can be connected to each of these jacks.
This is a 1/4" stereo phone jack.
The headphone output is the same signal as the MONITOR OUT L/R jacks.
5 VOLUME 1, 2 knob
This knob sets the volume level of the headphones. Turning the knob to the right
will raise the volume; turning the knob to the left will lower the volume.
6 CD-R/RW drive
This drive can be used to backup and restore data, or to play or write audio CDs.
The CD-R/RW drive is a precision device. You must operate the D32XD/D16XD in a hori-
zontal position, in a location that is not subject to vibration.
Inserting a disc
Make sure that the D32XD/D16XD is on.
(1)Press the eject button of the CD-R/RW drive to open the disc
tray. The tray will open about halfway. Manually pull the tray
out far enough to place a disc in the tray.
When opening the CD-R/RW drive for the first time, remove the pickup
stopper from the disc tray before using the drive.
(2)Place the disc accurately in the tray, label side up.
(3)Push the disk tray in until it is completely closed.
1
23
4
5 6
Eject button