Filter
Top Products
44
(4) Adjust the input level settings.
•Press the METER key to display the Meter Trk View
screen.
•Press the Meter Trk Type button to display the Meter
Trk Type dialog box.
• In “Select Level Meter Position,” set the level meter
mode to “CH-Input,” and press the OK button to
return to the previous screen.
• The CH1 and 2 level meters will move in response to
the input.
(5) Check the audio.
• Set the channel 1 and 2 faders to unity gain (0 dB).
• Access the MIXER, SOLO/MONITOR
, “Monitor”
tab page.
•Turn “Master LR” on (highlighted).
• Gradually raise the MASTER fader and PHONES
VOLUME knob or MONITOR LEVEL knob, and ver-
ify that you hear the sound from your headphones or
your monitor system connected to the MONITOR
OUT jacks.
1-2. Digital input
The D32XD/D16XD lets you input and record digital sources
from the S/P DIF or ADAT inputs.
You can input a digital source only if its sampling frequency
matches the sampling frequency of the currently selected song.
If you input a 24-bit signal into a 16-bit song, the sound you mon-
itor will be 24-bit, but it will be converted to 16-bit data when it is
recorded.
You cannot input from ADAT into a 96 kHz/24-bit song.
When making digital input settings for S/P DIF or ADAT, you
may hear noise due to synchronization difficulties. Please turn
down the faders or turn down the volume of your monitor speakers
before you adjust these settings.
Inputting the digital audio signal from a CD or DAT
Connecting the digital output of your external CD player
to the S/P DIF IN jack, and assigning it to channels 1 and
2.
(1) Connect your CD player.
Lower the D32XD/D16XD’s MASTER fader, and use an
optical digital cable to connect the digital output of your
CD player to the S/P DIF IN jack.
(2) Specify the S/P DIF inputs as the digital audio source.
• Access the MIXER, INPUT/OUTPUT/CH ASSIGN
,
“Ch Assign” tab page.
•Press the Select button, and in the Source select dia-
log box select “S/P DIF.”
• Adjust the synchronization settings. Add a check in
the “Change Sync source S/P DIF” check box.
The “Obey Copyright Rules” message will appear.
Carefully read “COPYRIGHT WARNING” (→p.iii) in
the owner’s manual, and if you accept the terms, press
the OK button.
• Select the channel 1 “SOURCE,” and use the
buttons to select “L” ( ). You can also use the value
dial or the +/– keys to make your selection.
In the same way, set channel 2 to “R” ().
(3) Assign the input audio to mixer channels 1 and 2.
(2)
D16XD
D32XD
(2)
(2)