Filter
Top Products
179
Appendices
TroubleshootingVarious messages
More about drives
and files
Installing the
options
Specifications
Various listsGlossaryIndex
Cautions when replacing the calendar
battery
• So that static electricity in your body does not damage
the electronic components, touch the ground wire of a
grounded device or an unpainted metallic component to
discharge any static electricity in your body before
installing an option board or memory. Internal compo-
nents of the D32XD/D16XD and of the option/memory
boards may be damaged by static electricity.
• Follow the installation instructions, being careful not to
reverse the polarity of the battery.
•Avoid touching exposed metal edges of the circuit board,
or portions that need not be handled during installation.
• All screws (and washers) that are removed will be used,
so be careful not to misplace them.
• Do not use screws other than those that are installed in
the D32XD/D16XD. Using screws of a different shape or
length may damage the unit or cause it to malfunction.
• Be sure to firmly tighten the screws used for attachment.
• When installing the battery, do not use excessive force.
Pressing the battery too hard or using excessive force
may cause malfunctions or damage.
• Make sure that the battery is completely inserted into the
battery holder. After installation, check to make sure that
the battery is firmly in place.
• When installing the battery, be careful not to drop it
inside the device.
If you drop the battery inside the device and are unable
to retrieve it, please contact your Korg distributor.
•You will need a Philips (“+”) screwdriver.
Use a screwdrive of the appropriate size for the screws.
The screw heads may be damaged if you use a screw-
drive of the wrong size.
Replacing the calendar battery
The calendar battery maintains the date and time that are
used to time-stamp data when it is saved. Use a CR2043 bat-
tery. Before you replace the battery, be sure to read “Please
read this before you begin installation” and “Before you be-
gin working” on p.176.
The following CR2032 batteries may be used with the
D32XD/D16XD
• Sony CR2032 batteries
Replacement procedure
1. You will need a Philips (+) screwdriver and a stack of
magazines or similar objects (used to prevent damage
to the keys and knobs, as shown in step 3 below).
2. Turn off the power of the D32XD/D16XD, and discon-
nect all cables.
3. As shown in the illustration below, place stacks of mag-
azines at the four corners to prevent damage to the
D32XD/D16XD’s knobs and keys, and place the D32XD/
D16XD upside down, supported by the stacks of maga-
zines.
4. Use the screwdriver to remove the four screws that hold
the HDD cover.
Be careful not to lose the screws you removed.
The hard disk is attached to the HDD cover. Do not subject it
to impact or vibration.
View from below
Place at each corner to avoid the key or knobs
HDD cover
Installing the
options