Filter
Top Products
172
The location cannot be stored.
The current location cannot be stored.
This CD is not playable.
The CD cannot be played because is not an audio CD or
because it has not been finalized.
This file name is already in use.
An identically-named file already exists.
→ Change the file name.
This format is not supported.
The inserted disc is in a format that the D32XD/D16XD
is unable to read.
This is a blank CD.
You have inserted a blank disc.
This operation is not available.
It is currently not possible to perform this operation.
To ~ End is out of range.
The track editing operation cannot be executed because
there is a problem with the TO and END locations you
specified.
→ The TO-END region must not exceed 12 hours (6 hours
at 96 kHz).
Too many files in this drive.
No more audio data files can be saved on the song drive.
→ Either erase the Undo data, or delete unneeded songs.
Alternatively, use a different song drive.
Too many REC-READY tracks for Punch Rec.
The number of tracks selected for recording exceeds the
allowable number of tracks for punch-recording.
→ Refer to “Recorder” (→p.64).
Track length is under 4 seconds.
When using Disc At Once to create an audio CD, the
data contained a track that is shorter than four seconds.
→ The minimum time for a track (the total of the song to be
written and the post-gap) is four seconds.
Trigger/RecStart is not available in MTC Master mode.
In order to perform Trigger/RecStart recording, the
MIDI Sync setting cannot be set to MTC Master.
Trigger/RecStart is not available in MTC Slave mode.
In order to perform Trigger/RecStart recording, the
MIDI Sync setting cannot be set to MTC Slave.
Trigger recording is not available for the master track.
You can’t perform trigger recording if the MASTER
TRACK STATUS key is set to REC.
Undo Data error.
The song cannot be selected or saved because there is an
error in the Undo data.
→ Delete the song that cannot be selected or saved.
→ Format the affected song drive.
Wrong disc.
The wrong disc is inserted for the operation you are
attempting to execute.
Confirmation messages
Info: “****”
This will appear when there is information to be
conveyed to the user.
→ Press the OK button and continue operation.
Serious error messages
Fatal: “****”
This will appear if a problem or malfunction has
occurred on the D32XD/D16XD.
→ If this type of message appears, write down the contents
of “****” and contact your Korg distributor.