Filter
Top Products
5 - 71
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid
(
: Valid, : Invalid)
MR-J3-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0 to 100 0 30122 30322 30522 30722
0 to 3000 70 30124 30324 30524 30724
1 to 2000 24 30125 30325 30525 30725
1 to 1000 37 30126 30326 30526 30726
20 to 50000 823 30127 30327 30527 30727
2: The PB
corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.