Filter
Top Products
4 - 13
MELSEC-Q
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
[Wiring example of shielded cable]
The following shows a wiring example for noise reduction in the case where the
connector A6CON1 is used.
To QD75MH
Connector
(A6CON1)
Shielded
cable
The length between the connector and the shielded
cables should be the shortest possible.
Use the shortest possible length to
ground the 2mm or more FG wire.
(The shield must be grounded on
the QD75MH side.)
For forced stop
input signal
For limit signal
and etc.
For manual paluse
generator signal