Filter
Top Products
2 - 4
MELSEC-Q
2 SYSTEM CONFIGURATION
2.2 Component list
The positioning system using the QD75MH is configured of the following devices.
No. Part name Type Remarks
1 Positioning module
QD75MH1
QD75MH2
QD75MH4
QD75MH
Number of control axes
MH: SSCNET model
2
GX Configurator-
QP
SW
D5C-QD75P-
E
Refer to GX Configurator-QP Operating Manual for details.
3 Personal computer
DOS/V personal
computer
(Prepared by user)
Refer to GX Configurator-QP Operating Manual for details.
4 RS-232 cable QC30R2
(Prepared by user)
An RS-232 cable is needed for connecting the CPU module with a
personal computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
5 USB cable –
(Prepared by user)
A USB cable is needed for connecting the CPU module with a personal
computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
6 Servo amplifier – (Prepared by user)
7
Manual pulse
generator
–
(Prepared by user)
Recommended: MR-HDP01 (Mitsubishi Electric)
8
SSCNET
cable
1
(For connecting
between the
QD75MH and the
servo amplifier)
–
(Prepared by user)
Cables are needed to connect the QD75MH with the servo amplifier.
9
Cable
1
(For connecting
between the
QD75MH and the
external device)
–
(Prepared by user)
Cables are needed to connect the QD75MH with the external device.
(Prepare them referring to the manuals for the connected devices and
information given in 3.4.2 of this manual.)
1: The SSCNET cable connecting the QD75MH and servo amplifier, external device connection connector has been
prepared. Refer to the below table.