Filter
Top Products
5 - 81
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid
(
: Valid, : Invalid)
MR-J3-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
1 to 200 3 30164 30364 30564 30764
0 to 1000 0 30165 30365 30565 30765
Encoder output pulse
phases selection
0
Encoder output pulse setting
selection
1: is used to set up the setting
value.
(Hexadecimal)
H
0000
H
30166 30366 30566 30766
Encoder cable
communication
system selection
0
1: is used to set up the setting
value.
(
Hexadecimal
)
H
0
0000
H
30167 30367 30567 30767
0 to 1 0 30168 30368 30568 30768
0 to 10000 50 30170 30370 30570 30770
0 to D
0
H
30172 30372 30572 30772
2: The PC
corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.