Filter
Top Products
5 - 89
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid
(
: Valid, : Invalid)
MR-J3-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Output signal device
selection 2
0
H
1: is used to set up the setting
value.
(
Hexadecimal
)
0
0004
H
30203 30403 30603 30803
Output signal device
selection 3
0
H
1: is used to set up the setting
value.
(
Hexadecimal
)
0
0003
H
30204 30404 30604 30804
2: The PD
corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.