Filter
Top Products
12 - 86
MELSEC-Q
12 CONTROL SUB FUNCTIONS
12.7.7 Acceleration/deceleration processing function
The "acceleration/deceleration processing function" adjusts the
acceleration/deceleration when each control is executed.
Adjusting the acceleration/deceleration processing to match the control enables more
precise control to be carried out.
There are two acceleration/deceleration adjustment items that can be set:
"Acceleration/deceleration time 0 to 3", and "acceleration/deceleration method setting".
The details shown below explain about the "acceleration/deceleration processing
function".
[1] "Acceleration/deceleration time 0 to 3" control details and setting
[2] "Acceleration/deceleration method setting" control details and setting
[1] "Acceleration/deceleration time 0 to 3" control details and setting
In the QD75MH, four types each of acceleration time and deceleration time can
be set. By using separate acceleration/deceleration times, control can be carried
out with different acceleration/deceleration times for positioning control, JOG
operation, OPR, etc.
Set the required values for the acceleration/deceleration time in the parameters
shown in the following table, and write them to the QD75MH.
The set details are validated when written to the QD75MH.
Setting item
Setting
value
Setting details
Factory-set
initial value
Pr.9
Acceleration time 0
1000
Pr.25
Acceleration time 1
1000
Pr.26
Acceleration time 2
1000
Pr.27
Acceleration time 3
Set the acceleration time at a value within the range
of 1 to 8388608 ms.
1000
Pr.10
Deceleration time 0
1000
Pr.28
Deceleration time 1
1000
Pr.29
Deceleration time 2
1000
Pr.30
Deceleration time 3
Set the deceleration time at a value within the range
of 1 to 8388608 ms.
1000
Refer to Section 5.2 "List of parameters" for setting details.