Filter
Top Products
12. Saving to Memory Card or Disk
124 RS7000
Formats memory cards and disks.
Format Procedure
1. Press the [SAVE] button 5 times from the PATTERN Play or
Patch mode to go to the Format page.
2. Press [F1] (CARD/SCSI) to specify whether you want to for-
mat a memory card or disk.
3. If a SCSI disk is selected, use [Knob 3] to select the type of
formatting you want to apply.
4. When the PARTITION format type is selected, use [Knob 4]
to select the disk partition to be formatted.
5. Press [F4] to begin the format operation.
6. The “Are you sure? NO[F2]/YES[F3]” confirmation message
will appear.
Press [F3] if it is OK to go ahead with the format operation.
Press [F2] to abort the format operation.
7. Press [EXIT] 5 times to return to the PATTERN Play or Patch
mode.
Display Parameters
[PATTERN] → [SAVE] × 5
CARD or DISK = SCSI
CARD or DISK = CARD
1
SCSI/CARD................................................................... [F1]
[Settings] SCSI, CARD
SCSI.............. The hard disk, ZIP disk, or other
SCSI disk connected to the SCSI
connector.
CARD............ A memory card inserted in the
card slot.
Selects the disk or memory card to be formatted.
When CARD is selected and a properly formatted memory
card is in the card slot, a memory card icon will appear.
When SCSI is selected and a properly formatted disk is con-
nected to the SCSI connector, a disk icon will appear along
with the disk description, SCSI ID number, and partition
name.
[5] Format Page
NOTE
Normally when formatting a hard disk, ZIP disk,
etc., it is best to start with LOGICAL formatting.
If LOGICAL formatting produces an error, then
try PHYSICAL formatting.
NOTE
• The format operation erases all data from the
target card or disk and is irreversible. Proceed
with caution.
• Before using the above procedure to format a
SCSI disk you will need to:
1. Press [LOAD] 3 times from the PATTERN
Play or Patch mode to display the SCSI
Setup page.
2. Use [Knob 1] (MOUNT ID) to set the
RS7000 SCSI ID number.
1 2 43
Partition Name
Disk Type
Icon
SCSI ID
[Knob 3] [F4][F1]
[Knob 4]
1 4
[F4]
[F1]