Filter
Top Products
2
The Pattern Mode
14. Pattern & Phrase Editing — The Pattern Jobs
RS7000 147
4 Split Measure
[Settings] 002 ~ source-phrase length
(in measures)
Specifies the measure at which the phrase will be split.
5
Split Destination Style,
6 Split Destination Phrase
[Settings] Style.............. OFF, 01 ~ 64
Phrase........... OFF, 001 ~ 256
Specify the destination style and phrase. After the Split
Phrase operation the section of the phrase before the speci-
fied split measure will remain in the source phrase, and the
section following the split measure will be moved to the split
destination phrase.
If the split destination style or section is OFF, the section
after the split measure will be erased.
Copies a segment of sequence-track data from a song into the
designated destination phrase.
1
Source Song, 2 Source Track
[Settings] Song.............. 01 ~ 20
Track............. 01 ~ 16
Specifies the copy source song and track.
3
Source Range
[Settings] 001 ~ 999
Specifies the range of measures to be copied.
4
Destination Phrase
[Settings] 001 ~ 256
Specifies the destination phrase.
5
Copy Sample
When the checkbox is checked sample voices used by the
source track are copied to the destination style as local sam-
ple voices, and are assigned to destination phrase.
This parameter has no effect when no sample voice is used by
the source track.
Copies a selected user phrase into a specified area of a selected
song.
1
Source Phrase
[Settings]
Phrase category US (User), Preset Phrase, see the
Appendix (Page 313) for information
on the phrase categories.
Phrase Number 001 ~ 256 (The available range may
change depending or the category.)
Specifies the source phrase.
23 Get Phrase
CAUTION
The job overwrites any data already existing in
the destination phrase.
1 2 3
45
[Knob 2] [Knob 3] [F4]
NOTE
• When there is no memory available in the des-
tination style for local sample voice data, “Too
Many Local sample Voices” will appear on the
display and the sample voice data will not be
copied. If this occurs, use Sample Job “02
Delete” (Page 246) to delete unused local
samples then try again.
• Undo/Redo (Page 134) can be used after a
sample voice copy operation, but will not
apply to the sample voice.
• When the “5. Copy Sample” box is checked
and the [F4] (DO!) button is pressed, the “Are
You Sure? Cancel [F2]/OK [F3]” confirmation
prompt will appear. [F3] will execute the Get
Phrase job.
24 Put Phrase
CAUTION
The job overwrites any data already existing in
the destination track.
1 2
3
4
5
[Knob 2] [Knob 3] [F4]