Filter
Top Products
7. Pattern Chain Editing
RS7000 175
3
The Pattern Chain Mode
The Pattern Chain Edit mode makes it possible to edit the order of the patterns in a chain as well as
inserting tempo, and scene/mute event data.
Press [EDIT] from the PATT CHAIN Play mode to go to the Pattern Chain Edit Change page.
Pattern Chain Edit Procedure
1. Select the pattern chain you want to edit in the PATT CHAIN
Play mode.
2. Select the track to be edited by pressing the appropriate key
on the keyboard while holding the [TRACK SELECT] but-
ton. If a track 1-16 is selected, you will enter pattern track
editing.
3. Press [EDIT] to go to the PATT CHAIN EDIT Edit Change
page.
When the BPM or SCENE/MUTE track is selected
BPM (tempo) and scene/mute events can be edited or deleted via this dis-
play page. To insert a new event press [F3] to go to the event type selec-
tion page.
4.
Use [Knob1] to move the cursor to the event to be edited.
5. Use [Knob 2] to move the cursor to the event parameter to be
edited, and use [Knob 4] (VALUE) to change the value as
required. An edited event will flash on the display.
• The measure, beat, and clock of an even can be edited to change its
location.
• While an event is flashing (being edited), you can use the SUB
MODE buttons as a numeric keypad to directly enter parameter
values.
6.
When the parameter has been edited as required, press
[ENTER] or [F3] (DO!) to confirm and enter the edit (the
event will stop flashing).
• If the cursor is moved to a new event while the current event is still
flashing, editing of the current event is cancelled.
7.
Press [F2] (DELETE) to delete the event at the cursor posi-
tion.
8. Press [F3] (INSERT) go to the Insert page if you want to
insert new tempo or scene/mute events.
Set the measure, beat, clock, and parameter, and then press
[F3] (DO!) insert the event.
9. Press [EXIT] to return to the PATT CHAIN Play page.
When a pattern track is selected
In this display the style, section, and meter can be edited for each mea-
sure.
4.
Use [Knob 1] to move the cursor to the measure to be edited.
5. Use [Knob 2] to move the cursor to the meter, style, or sec-
tion to be edited, and use [Knob 4] (VALUE) to change as
required.
• When a style is turned OFF, a corresponding blank section is pro-
duced during pattern playback (playback does not stop).
7. Pattern Chain Editing
NOTE
• Before entering the Pattern Chain Edit mode be sure to turn Memory Protection OFF: go to the UTILITY
mode System page (Page 257) and turn MEMORY PROTECT “OFF”.
If memory protect is ON “Memory Protected” will appear when the [EDIT] button is pressed and pattern
chain editing will not be possible.
• The Solo function cannot be used during pattern chain editing.