Filter
Top Products
Appendix
1. Installing Optional Equipment
RS7000 277
4. Plug in the flat cable backward.
• Disconnect the flat cable.
• Insert the opposite plug into the connector.
The connector has a cut-out that prevents it from being connected in an incorrect orientation.
5. Connect the flat cable.
• Connect the flat cable from the I/O expansion board (the thin, flat cable) to the corresponding connector on the RS7000’s circuit
board (marked “C” in the illustration below: CN16).
The connector is “keyed” so that it will only go in one way.
6. Insert the AIEB2 I/O expansion board.
• Support the I/O expansion board as shown in the illustration below, and fasten it to the rear panel by screwing in the three screws
(B) that you removed at Step 3 above.
I/O cover
(B)
CN 16
C
(B)