Filter
Top Products
1. Installing Optional Equipment
278 RS7000
7. Connect the 3-wire red/white cable.
• Of the two red/white cables that extend from the I/O expansion board, first connect the 3-wire cable to the connector shown in the
illustration below (CN7: 3-pin).
Make sure that the direction is correct, and do not try to force the connection.
8. Connect the other red/white cable (4-wire) in the same way.
• Connect the cable to the connector shown below (CN2: 4-pin).
9. Secure the cables to the bundle tie.
• Run the 3-wire and 4-wire cables through the bundle tie (see illustration below), and secure them.
CN 7
CN 6
CN 1
CN 4
CN 2
CN 7
CN 6
CN 1
CN 4
CN 2
Bundle tie