2. Combining Phrases to Create Patterns (Patch)
76 RS7000
9 Track
Track numbers.
The currently selected track number is highlighted.
0
Track Status
Indicate whether the corresponding track contains data, as
well as the status of the track.
:Sample data is assigned to this track.
:The track is muted (no sound will be produced by this
track).
[S]:The track is soloed (all other tracks are temporarily
muted and only this track will sound).
Pattern Assembly Procedure
1. Use the [UTILITY] MODE button to access the SYSTEM
page, then use [Knob 4](MEMORY PROTECT) to turn
MEMORY PROTECT “OFF” (Page 257).
2. Press [PATTERN] button to go to the PATTERN Play page,
and set the STYLE and SECTION parameters to select the
pattern you want to create.
You can give the style a name, if required (Page 153).
3. Press [F3] to move the cursor to the LENGTH parameter, and
use [Knob 3](LENGTH) to set the length of the pattern.
4. Press [F1] to move the cursor to the METER parameter, and
use [Knob 1](METER) to select the desired meter.
5. Press the [PATTERN] button again to go to the PATTERN
Patch page.
6. Select a track to which you want to assign a phrase (Page 67).
7. Use [Knob 1](PHRASE CAT.) and [Knob 2](PHRASE NO.)
to select the phrase to be assigned to the selected track. Press
[PLAY] to hear the phrases during selection.
8. If necessary use [Knob 3](NOTE SHIFT) to set a note-shift
value for the current phrase.
9. To adjust the BPM, press [PATTERN] to return to the PAT-
TERN Play mode and use [Knob 4](BPM) to adjust as
required.
10. Use the SUB MODE buttons (GROOVE … SETUP) to set
other parameters as required (refer to the respective SUB
MODE sections of the manual).
