Filter
Top Products
6. The Pattern Chain Jobs
RS7000 171
3
The Pattern Chain Mode
The RS7000’s 9 pattern chain “jobs” can be used to edit and modify pattern chain data in a number of
ways.
● Job List
Pattern Chain Job Procedure
1. Press the [JOB] button from the PATTERN Chain Play mode
to go to the job list.
2. Use [Knob 1] (CATEGORY) and [Knob 2] (JOB) to move the
cursor to the desired job.
3. Press [F4] (SELECT) to jump to the selected job page.
4. Use [Knob 2] (CURSOR ← →) to move the cursor to the var-
ious parameters, and [Knob 3] (VALUE -/+) or [SHIFT]+[F3]
→ Numeric Keypad to set the parameter values as required.
5. When the parameters are set press [F4] (DO!) to execute the
job. “Completed.” will appear when the job is done.
6. Press [EXIT] twice to go back to the PATTERN Play or Patch
mode.
Precautions
• If there is no data in the specified range “No Data” will appear
on the display and the job can not be executed.
• If you make a mistake or want to compare the sound of the
data before and after executing a job, use the Undo/Redo func-
tion (Page 172).
6. The Pattern Chain Jobs
[Undo/Redo Category]
00 Undo/Redo Undo cancels the changes made by the most recent opera-
tion, restoring the data to its previous state, while Redo
restores the “undone” change.
P.172
[Event Category]
01 Copy Event Copies all data from a specified source range to a specified
destination location.
P.172
02 Erase Event Clears all events from the specified range. P.172
[Measure Category]
03 Create Measure Creates empty measures at the specified location. P.173
04 Delete Measure Deletes the specified measure(s). P.173
[Convert Category]
05 Convert To Song Converts the current pattern chain to performance data and
copies the data to a specified song.
P.173
[Chain Category]
06 Copy Chain This job copies all data from a selected source pattern chain
to a selected destination pattern chain.
P.174
07 Clear Chain This job deletes all data from the selected pattern chain. P.174
08 Chain Name Use this job to enter or change a pattern chain name. P.174
[Knob 2][Knob 1]
[F4]
Category
Job
NOTE
If the memory protect function is ON, “Memory
Protected” will appear on the display when the
[JOB] button is pressed and it will not be possi-
ble to access the job list. In this case go to the
UTILITY mode System page (Page 257) and
turn MEMORY PROTECT “OFF”.