Filter
Top Products
4. The Sample Jobs
250 RS7000
4 LENGTH..................................................................[Knob 4]
[Settings] 0 ~ End Point
Specifies the length of the fade-in or fade-out in 100 steps.
When a fade-in is selected this parameter specifies the length
of the fade starting at the specified START or
START(ATCK) point.
When a fade-out is selected this parameter specifies the
length of the fade starting at the beginning of the fade and
ending at the specified END point.
5
AUDITION.......................................................................[F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to apply a fade-in or fade-out to the sample.
6 DO!....................................................................................[F4]
Executes the job.
7
CREATE..........................................................................[F3]
Saves the processed sample to the target sample number,
overwriting the original sample. If the original sample is a
Pitched Sample it will be overwritten at this point.
If the original sample is part of a Sample Kit Voice a key-
number selection page will appear.
8
CREATE TO
(Destination Key Number).............................[Knob 2]
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
9
OK......................................................................................[F3]
Saves the processed sample to the specified destination key
number.
Halves the sampling frequency of the specified sample. This can
be used to convert hi-fi samples to a lo-fi sound, and reduce the
sample size by half.
1
SAMPLE (Sample Number).......................... [Knob 1]
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be converted.
2
KEY (Key Number) ........................................... [Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the sample to be converted.
3
AUDITION...................................................................... [F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to apply frequency conversion to the sample.
4
DO!................................................................................... [F4]
Executes the job.
5
CREATE......................................................................... [F3]
Saves the processed sample to the target sample number,
overwriting the original sample. If the original sample is a
Pitched Sample it will be overwritten at this point.
If the original sample is part of a Sample Kit Voice a key-
number selection page will appear.
98
[Knob 2] [F3]
09 FREQUENCY CONVERT
NOTE
This parameter is not available when the speci-
fied sample is a Pitched Voice.
4512
3
[Knob 1] [Knob 2]
[F3] [F4]
[F2]
76
[Knob 2] [F3]