Filter
Top Products
2
The Pattern Mode
8. Changing the Sound of Voices (Voice Edit)
RS7000 99
Specifies the LFO waveform. A total of 7 waveforms are pro-
vided.
Press [F4] to go to the USER wave setup page.
TRI (Triangular wave)
SAW UP (Rising sawtooth)
SAW DOWN (Falling sawtooth)
SQU (Square wave)
S/H (Sample & hold)......... Random Variation
■ User Wave Page
9
SLOPE.................................................................... [Knob 1]
Absolute
[Settings] OFF, UP, DOWN, UP&DOWN
OFF...................The waveform steps are not con-
nected by slopes. The wave will be
similar to a rectangular or sample-&-
hold wave.
UP .....................Slopes will be used to connect only
steps which increase in amplitude.
This produces composite rising saw-
tooth type waveforms.
DOWN...............Slopes will be used to connect only
steps which decrease in amplitude.
This produces composite falling saw-
tooth type waveforms.
UP&DOWN .......Slopes connect all steps. The result is
a composite triangular waveform.
Determines whether or not the steps of a user waveform will
be connected by slopes.
0
STEP/TOTAL ............................[Knob 2], [F2] → [Knob 2]
Absolute
[Settings]
STEP.................1 ~ TOTAL STEP
TOTAL ..............2, 3, 4, 5, 6, 8, 12, 16
STEP selects the step in the user waveform for which the
amplitude will be specified via the STEP VALUE parameter,
below.
TOTAL specifies the total number of steps per one cycle of
the user waveform. More steps allow more complex wave-
forms.
Press [F2] to move the cursor to the TOTAL parameter and
set the total number of steps using [Knob 2].
Variation
Time
Variation
Time
Variation
Time
Variation
Time
Variation
Time
90AB
C
[Knob 1]
[Knob 2]
[F2]
[Knob 4]
[F4]
[F1]
[Knob 3]